95 Vacuum line routing?

GRWeldon

5th Gear Poster
Joined
Oct 5, 2023
Messages
458
Location
Alabama
Country flag
Unfortunately the vacuum line T at the back of a 95 4.6 crumbled when I touched it. I have a replacement but I can't figure out how to route the lines. Searching the internet doesn't turn up much useful info. You would think there would be line routing diagrams on at least one Tbird site. Does anybody have a diagram for a 95 4.6 Tbird or a picture of where the lines from the rubber T actually attach? I'm waiting to install the engine back in because you really can't get to these lines when the engine is installed...

Thanks...
 
Sorry, no really good pictures or diagrams, just a couple from ones I took during an intake job that show in what direction the tubes connected to the T go. The one on the driver side goes underneath. There's a write-up on "how to replace all the vacuum lines on your 4.6" somewhere, I don't have a link but have a printout.

This might help.

 

Attachments

  • MVC-129S.JPG
    MVC-129S.JPG
    149.7 KB · Views: 4
  • MVC-134S.JPG
    MVC-134S.JPG
    122.6 KB · Views: 4
Thanks man. I pulled my head out of my rear end today and figured out what the diagram on the core support was showing. Looks just like yours pics now!
 

Similar threads

Back
Top