Rotors for Hub Swap, PBR setup

[Bill H]

I think I'm going to spring for new slotted, drilled rotors. The old ones are rusty and plain. I've been reading old posts to confirm purchase.
I am running Mustang hubs, PBRs, with OE Mach 1 wheels. Current rotors are just under 11 (10.8ish?)

Does anyone have a recent RockAuto code?

I'm planning to get the 04 Mustang/V6 rotors below. Tell me now if I'm wrong

POWER STOP AR8141XPR

130 for the pair.

 

[MadMikeyL]

You are correct to order rotors for a 99-04 Mustang V6 or GT. You are wrong to order drilled/slotted rotors. Drilled/slotted rotors are a scam based on an incorrect understanding of why they were originally used on race cars. They not only provide zero benefit on a street car, they actually marginally hurt your braking performance. Also more often than not they squeak, squeal, whistle, or make other unpleasant noises when braking. Get a good quality pair of regular vented rotors.

 

[Ericv8thunderbird]

I’ve seen many instances where drilled rotors crack.

I’m running slotted rotors for a 99-04 Cobra without any issues.

 

[XR7-4.6]

If you want the best longes lasting braking performance solid stock style rotors are better. Drilled and slotted is just for looks, the latter being better than drilled if you must

All I can think of with slotted rotors though is when I put a set on my friends SC and every time he’d apply the brakes you’d hear “ffffffttttt….ffffftttttt…..ffffftttt…..fffffftttttt” it was like the big boy equivalent of baseball cards in the spokes. He glanced at me and I just said” I told you these rotors were silly”

 

[Zep5.0]

But dang they look good. These are power stop, but slightly bigger.

 

[XR7-4.6]

View attachment 16561

But dang they look good. These are power stop, but slightly bigger.

The non swept area being brand new is what really looks nice, once it gets a layer of surface rust it looks like any other rotor… but with holes lol

 

[Trunk Monkey]

A certain amount of heat check cracking in drilled rotor holes is acceptable. My rotors have some small cracks in them that have been there for some time.

Cracks are acceptable provided that:

• Small heat check cracks at the holes are acceptable up to 3/16 of an inch.
• They do not connect hole to hole.
• They do not reach to the outer edge of the rotor.
• They cannot be felt deeply when running a fingernail over them.

Replace the rotor if:

• Cracks are greater than 1/4 inch in length
• Cracks connect hole to hole or hole to outer edge of rotor
• Cracks can be clearly felt and the crack is widening
• You see chunks missing
• You feel vibration under breaking