Holes?!

[Ericv8thunderbird]

Since the weather hasn’t been all that great lately I figured I’d get a head start on getting ready for my SVO supercharger.
I bought an Autometer Wideband gauge and need to run this plug from the inside of the car to the outside. Before I go tearing up my interior, does anyone know if there is a grommet under the center console or driver side floor I can run this huuuge plug through?

 

[Rodeo Joe]

Here's a couple of pictures I took of my interior during my rodent clean up fiasco, hopefully they help you out.

Joe

 

[MadMikeyL]

If you look in Joe’s first picture, just below the center of the dashboard on top of the transmission tunnel is a round grommet. If you pull that out and cut a slit in it, you can put the connector through the hole and slide the wiring through the slit back into the grommet.

 

[XR7-4.6]

I used one of the grommets in the lower A pillar area and just snaked the cable through the kick panel into the interior. Least intrusive way I could think to do it

 

[Swamprat]

No easy solutions. One of the reasons when I installed NOS factory driving/fog lights I used a wireless controlled relay to be able to turn them off and on.

 

[dDUBb]

It might be possible to de pin the bulky connector so you can run just the wire through a smaller grommet.

 

[Ericv8thunderbird]

View attachment 5280View attachment 5281

Here's a couple of pictures I took of my interior during my rodent clean up fiasco, hopefully they help you out.

Joe

This is perfect!

 

[Zep5.0]

 

[racecougar]

I de-pin and re-pin connectors like that to keep the pass through hole as small as possible. I also like to utilize cable glands rather than grommets to better isolate and seal the hole.

 

[Zep5.0]

I can always grab exact measurements if needed

 

[Grog6]

I have similar holes in my floorboard.